How to use the slag remover well, the use and operation of the high concentration slag remover:
1. The high concentration slag eliminator can be used in a single set, or in parallel with several sets in the process with large production capacity.
2, high concentration dredger before starting, should first open the lower high pressure water valve, make the dredger tank and dredger filled with water, and then open the slurry pump, adjust the high pressure water flow, so that the size of the lower cone and the balance of water contact in the middle of the endoscope, prevent the fiber into the dredger tank.
3. Observe the pressure gauge on the inlet and outlet slurry pipe and adjust the flow control valve to make the inlet and outlet pressure difference meet the process requirements.
4. Operation method of high concentration slag eliminator:
(1) When using automatic slag discharge, the user should set the appropriate slag discharge control time according to the amount of slurry containing slag.
(2) When manual slag discharge is adopted, the height of heavy impurities accumulation in the tank should be frequently observed during operation. When the tank is to be filled, close the upper gate valve and high pressure balance water valve, open the lower slag discharge valve, and discharge heavy slag; After the heavy slag discharge, close the lower slag discharge valve, open the exhaust valve and high-pressure water valve, and close the exhaust valve and open the upper gate valve after the tank is full of water, and adjust the high-pressure balanced water flow to meet the requirements.
Zibo Yunfeng industrial ceramics Co., LTD. Was founded in 2001, the main products are medium and low concentration slag eliminator, high concentration slag eliminator, alumina ceramics, alumina products, wear-resisting ceramic pipes, dewatering components, mining equipment and accessories, etc., inquiry hotline :13806435563.